For one goal: the least thinset to dig out of grout lines. Assumes you floated or self-leveled first, so the floor and walls are flat. Flat substrate is what lets you run small notches.
Pill = how much squeeze-up to expect if you do nothing special.
1.5" hex, other sheet mosaics, 11×13 sheets. Walls and floors.
3×6, 3×8, 4×8. Longer pieces like 4×12 go up one size.
Ceramic or porcelain.
6×6 or 8×8. Thick, uneven backs, wide joints.
If it's a mosaic sheet, use the mosaic row instead.
Walls and floors.
Cleanup kit: grout float or beating block, utility knife, stiff toothbrush, leveling clips for 12×24, a bucket of clean water and a sponge.
| You see | Do this |
|---|---|
| Thinset coming up in every joint | Mix stiffer, flatten ridges, or drop one notch size. |
| Bare spots on a pulled tile | Heavier skim on the back. Only then go up a notch. |
| Mosaic pieces sinking or sitting uneven | Mix stiffer and press with the float, not your fingers. |
| Thinset already hard in joints | Grout saw or oscillating tool before grouting. Grout can't cover it. |
| Hollow-sounding 12×24 corner | Pull it now while you still can. Heavier skim, reset. |
Coverage targets, for reference: about 80% contact in dry areas and 95% in showers and wet floors, with corners and edges supported. Walls tolerate less than perfect. Floors under 12×24 and anything in a shower don't.